Professional Automotive Test leads AideTek PA000 used on Pico Oscilloscope TA000

Description

New Professional Automotive Test leads AideTek PA000
brand new with 1 yr USA warranty can be used on Pico Oscilloscope
The test lead has been custom made for automotive use with a Pico automotive oscilloscope or other auto Oscilloscope. Its length (3 meters / approx 10 ft) allows the oscilloscope to be placed on the work bench away from the car being tested / repaired. A wide range of probes, clips and gators can be plugged into the 4 mm connectors at the end of the cable. The cable is fully screened to reduce noise pickup
You may also need the Secondary ignition Pickup lead (
New Secondary Ignition Probe X10000 pickup auto scope
) should be used for your Pico Oscilloscope.
The
Secondary Ignition Probe
allows the oscilloscope function to measure the Kilovolts value of ignition systems with Distributorless system (DIS) or conventional ones.
The Secondary ignition probe  obtains the signal using a capacitive clip and a conditioning circuit in order to deliver a readable waveform to the oscilloscope.
Due to the high voltages involved in secondary ignition systems, it is not possible to make measurements by direct connection; attempting to make a direct connection will almost certainly damage the measuring instrument.
The Auto-probe is a kind of inductive capacitance-probe, which should be used with the oscilloscope to test the waveform as the "primary parade waveform", "secondary parade waveform" To accomplish the purpose of inspecting the ignition-system of the engine. By this method, you could see the variation of the ignition-system voltage via the time on the screen of the oscilloscope directly.
To ensure the proper operation, please note:
1> The test-clip should be connected to the isolative wire of ignition plug instead of ignition plug itself to prevent the fire of electrical shock.
2> At least 2inchs away from other high-voltage wires to avoid the interference.
Cable length: 100 inch or 2.50m
This is a capacitive pickup that simply connects around the insulation of an ignition circuit component such as a plug wire — this avoids the need for direct connection.
It comes with a shielded 2.5m (100 inch) lead. It is suitable for use with conventional ignition systems and most HEI and DIS systems.
and
passive 20:1 attenuator voltage 300V fit pico scope New
Hantek HT-201 300V 20:1 Passive Attenuator for Oscilloscopes
Hantek HT-201 can be used to measure fuel injector and primary ignition waveforms utilizing an oscilloscope of any brand.
Specification :
Attenuation : 20:1
Input impedance : 1.053 mohm
Input capacitor : 11pf
Bandwidth : 10mhz(-3db)
Max. voltage : 300V